Desa 80-CC Manuel D'utilisation page 4

4
1. Care must be taken to protect hands during this
step. Lift outer shell straight up as shown in Fig-
ure 2, until all three clips engage slots in lower
shell. Screw holes will line up at this point.
2. Lock clips into place with 3 screws as shown
in Figure 2. The heater must not be operated
unless the outer shell is properly extended and
fully locked into place.
www.desatech.com
Outer
Shell
Figure 2 - Lifting Outer Shell
(200,000 Btu Model Shown)
3 Screws
per Clip
116557-01A