Pairing A Bluetooth Device - Audio-Technica ATH-AR3BT Manuel De L'utilisateur

Connecting via Bluetooth wireless technology
About pairing
To connect the product to a Bluetooth device, the product needs to pair (register) with the device. Once they are
paired, you do not need to pair them again.
However, you will need to pair again in the following cases:
• If the product is deleted from the Bluetooth device's connection history.
• If the product is sent out for repair.
• If the product is paired with 9 devices or more.
(The product can be paired with up to 8 devices. When you pair with a new device after pairing with 8 devices, pairing
information for the device with the oldest connection date will be overwritten by the information for the new device.)

Pairing a Bluetooth device

• Read the user manual for the Bluetooth device.
• Place the device within 1 m (3.3') of the product to perform pairing correctly.
• To confirm the progress of the pairing process, wear the product while performing this procedure and listen for the
confirmation tone.
1. Starting with the product turned off, slide the power switch to the "ON"
position.
• The indicator lamp will light in blue, and then flash in red and blue.
• The product sounds a confirmation tone when pairing begins.
2. Use your Bluetooth device to begin the pairing process and search for the product.
• For information about using your Bluetooth device, refer to the device's user manual.
3. Select "ATH-AR3BT" to pair the product and your Bluetooth device.
• Some devices may ask for a passkey. In this case, enter "0000" . The passkey
may also be called a passcode, PIN code, PIN number, or password.
• The product sounds a confirmation tone when pairing is complete.
Settings Bluetooth
Bluetooth
MY DEVICES
ATH-AR3BT
6