Toshiba ESTIA HWS-802XWHM3-E Manuel Du Propriétaire page 11

Hydro Unit
Setting schedule
Press the SCHEDULE
more to enter the schedule setting mode.
Perform the following procedure to set the
schedule
• First schedule setting
1 2 3
→ →
Procedure:
• Existing schedule setting
2 3 4
→ →
Procedure:
1
Set days of the week.
• Each time the DAY
mark blinking on the current day of the week at
intervals of 1 Hz shifts sequentially.
• When all days are set at a time, all days (MO to
SU) blink.
• Press the SET
days of the week.
• When the setting is completed, the
changes to lighting.
2
Set STEP.
• Select a STEP to be set with the STEP
button, and press the SET
determine the selected STEP.
1 → 2 → 3 → 4 → 5 → 6 → 7 → 8 → C → L →
1 → ....
• 1 to 8: Operation program STEP number
• C (Copy):
Set s the operation mode for a day (0:00 to
23:59) simultaneously.
• L (Deletion):
Deletes all the current program operation
settings (for entire week).
button for 4 seconds or
4 5 6
→ → →
5 6
→ →
button is pressed, the
button to determine the set
mark
button to
3
Set the start time.
• Set the start time with the TIME
buttons.
• When the preset start time is retained, the start
time is displayed.
• If no start time is set, "--'-- --" is displayed.
4
Set temperature.
• Set the temperature for ZONE1 or ZONE2 with
the SELECT
buttons.
• Press the SELECT
the mark lights for the zone to be changed.
• Enter setting temperature with the TEMP.
buttons.
5
Set operation mode.
• Set the operation mode (heating or cooling) with
the OPERATE MODE
6
Determine the settings.
• Press the SET
settings.
• The "__" mark lights under the set day of the
week and the "
for 4 seconds.
• Press the SCHEDULE
the settings.
Copying data
When "C" is selected during the STEP setting, the
setting of the specified day of the week can be copied.
• Press the SET
mode.
• Specify the day of the week of copy destination with
the DAY button.
• Each time the DAY
mark on the specified day of the week blinks
sequentially. When all days of the week are blinked,
the data can be copied to all days of the week.
• Press the SET
appears on the remote controller for 4 seconds, the
setting is completed.
– 11 –
Owner's Manual
button and TEMP.
button so that
button.
button to determine the
" mark appears on the display
button to end
button to determine the copy
button is pressed, the
button. When the " " mark
EN
10-EN