Disabling Intel® Optane - Captiva Power Starter I61-873 Guide Utilisateur Concis

10. Follow the on-screen instructions to install the Windows 10
operating system.
11. Install the Windows drivers (see
the Intel® Rapid Storage Technology (IRST) driver.
12. Run the Intel® Optane™ Memory and Storage Management
application.
13. Click Enable Intel® Optane™ Memory.
Figure 2 - Intel® Optane™ Memory and Storage
Management - Enable Intel® Optane™ Memory
14. A warning will pop up to notify you that all data on the Optane
Memory Module will be erased, and if this is OK then click
Enable.
15. The system will prepare and enable the Optane drive, and when
finished you can then click Restart.
16. The system will then optimize the Optane Memory upon restart.
17. Run the Intel® Optane™ Memory and Storage Management
application.
18. The system status will then be displayed.
6
page 20). Make sure you install
Disabling Intel® Optane™
If you wish to disable an existing Intel® Optane™ setup
then follow the procedure below to do so.
1. Run the Intel® Optane™ Memory and Storage Management
application.
2. Click Intel® Optane™ Memory and then click Disable.
3. Click Disable when you see the following message.
Figure 3 - Intel® Optane™ Memory and Storage
Management - Disable
4. Restart the computer to complete the process.
5. Run the Intel® Optane™ Memory and Storage Management
application.
6. The Intel® Optane™ Memory Status is indicated in the
Window.