Young Living Feather the Owl Mode D'emploi page 12

Unplug the diffuser before performing the following procedures:
Issue: The light does not work.
Potential cause: power connection
Issue: When switched on, the light flashes once, then turns off.
Potential cause: no water in diffuser
12
Feather The Owl Diffuser Manual V2_US.indd 12
• Check the water level. If water is above the fill line, carefully pour out
excess water. This is best done by pouring from the opposite side of the
base ventilation hole.
• Verify that when the lid is in place, the mist spout hole is clear and free
from any debris.
• Check for essential oil buildup on the ultrasonic plate. If oil buildup is
present, follow the cleaning instructions. The ultrasonic plate must be
free of residual oil buildup for the diffuser to operate properly.
• Check that the fan intake under the diffuser is free of any obstruction or
debris that may restrict air flow. Once the diffuser is on, you should hear
the fan.
• Refill the water reservoir to the water fill line marker and restart. If
necessary, remove the lid while the diffuser is on to verify that the water
is bubbling. If the water is bubbling, the ultrasonic plate is working. If the
water is not bubbling, the ultrasonic plate may be damaged.
• While facing the diffuser, touch the left middle toe (on/off button) to
verify that the diffuser turns on and that the light is functioning. While
the unit is on, light colors should change while touching the right middle
toe. If the light does not work, call Member Services for
further instructions.
• The unit is not registering water in the diffuser. Check that there is water
in the reservoir and that it is not above the water fill line marker. If there
is too much water, unplug the diffuser and adjust the water to the fill line
and restart.
6/21/19 10:50 AM