Maintenance; Disposal; Technical Data - Cedes GridScan/Mini-SR Manuel D'installation

GridScan/Mini-SR

11. Maintenance

Although the GridScan/Mini-SR does not need regular
maintenance, a periodical functional check is strongly
recommended as follows:
 The optical sensor elements are clear of dirt and dust.
If necessary, clean the front surface with a soft towel.
 The edges are securely fastened.
 The cables are fixed properly.
 The Safety Unit FSS is securely fastened.
NOTICE
Damage to the optical elements
 Never use any solvents cleaners or mechanically
abrasive towels as well as high pressure water
to clean the edges. The front window may be
damaged!
 Also avoid scratching the edges while cleaning.

12. Disposal

The GridScan/Mini-SR should only be replaced if a similar
protection device is installed. Disposal should be done
using the most up-to-date recycling technology according
to local regulations and laws.
There are no harmful materials used in the design and
manufacture of the sensor. Traces of such dangerous
materials may be found in the electronic components but
not in quantities that are harmful.

13. Technical data

Optical
Max. operating range
Number of elements
Max. ambient light
Mechanical
Cross section
Max. protection height
Housing material
Enclosure rating
- Edges
- Safety Unit FSS
Temperature range
8
0.5 ... 1.5 m
43
100,000 Lux
12 mm × 16 mm
1,805 mm
Natural anodized
aluminum
IP65
IP66
−25 °C ... +60 °C
Electrical
Supply voltage U
SP
Current consumption
at 24 VDC
Relay output
Typ. response time
Status LED Rx:
- Object detected
- No object detected
Power LED Tx: Power OK
Connection cable and electrical connection
Synchronization cable
Length
Diameter
Material
Plug color
Wires
brown
•
blue
•
black
•
white
•
Connection cable to Safety Unit FSS
Length
Diameter
Material
Plug color
Wires
brown
•
blue
•
black
•
white
•
gray
•
green
•
General
EMC emission
EMC immunity
Vibration
Shock
RoHS
Certificates
Safety category
English
24 VDC ±20%
230 VAC
150 mA
Max. 250 VAC / 3 A
Max. 30 VDC / 3 A
Min. 5 VDC / 10 mA
140 ms
Red
Green
Green
3 m
Ø 3.5 mm
PVC, black
Black
AWG26
U edges
SP
GND (0 V)
Communication
Test signal
3 m
Ø 4.2 mm
PVC, black
Blue
AWG26
U edges
SP
GND (0 V)
Output (FSS)
Test input
Not used
Not used
EN 61000-6-3:2007
EN 12015:2014
EN 61000-6-2:2005
EN 12016:2013
IEC 60068-2-6:2007
IEC 60068-2-27:2008
2011/65/EU
CE, TÜV
EN ISO 13849-1:2008,
Cat. 2, PL D
© CEDES | V 2.0