Warning: Safety Precautions; Before Using - Remington Power Pro 500V Mode D'emploi

The following pages contain detailed warnings, cautions, and rules of safe operation.
Read carefully and become familiar before operating to avoid serious injury. We
expressly disclaim any liability for any injury to persons or damage to property which
result from your failure to take the precautions contained in this manual.
!
WARNING: This tool is designed only for use by qualified operators. Qualifica-
WARNING ICON G 001
tion is obtained through a thorough understanding of the Safety Precautions and
operating instructions as defined in this operating manual. NOTE: The labor regula-
tions of many states require that the operator of this tool on a job site be thoroughly
trained and certified for competence prior to operating this tool. For certification
procedures, call: DESA Specialty Products™ Technical Services Department, 1-800-
858-8501 (USA) or 1-905-826-8010 (Canada) or visit www.desatech.com.

BEFORE USING

1. ALWAYS handle the tool as if it were loaded. Before starting work, check that
the tool is unloaded and the muzzle is clear. NEVER load a tool unless it is going
to be used.
2. ALWAYS inspect to make sure the tool is working properly. If the tool does not
work properly, remove from service and tag DEFECTIVE. DO NOT use the tool
again until it has been properly repaired.
G 018
3. Operators and bystanders must ALWAYS wear goggles and ear protection
which meet or exceed the accepted standards for adequate protection in your
country. In the USA, refer to ANSI standards. In Canada, refer to CSA standards.
114918
!
Warning: Safety
WARNING ICON G 001
Precautions
G 018
3