Dog trace X30 Mode D'emploi page 21

3. Select the parameter you wish to set by using
pressing and holding the MENU push button.
4. Use the arrows
above, press .
5. When the BEEPER is fully set, return to the main screen by pressing repeatedly
Setting mode –
We may select 7 modes:
Mode
Description
No.
WARNING: The acoustic and vibration indication may be set up for up to 4 dogs.
When the sound and vibration indication is set, individual dogs may be identified
by the number of beeps/vibrations (max. of 4 beeps or vibrations) indicating dog
at motion/standstill. If the acoustic and vibration indication is set for more dogs,
the acoustic and vibration indication are simultaneous.
Mode 3 and 4 are intended for hunting wild boars. The indication (acoustic or
vibration) is activated if the dog moves within the radius r, for the duration t (time).
Setting of sensitivity –
The sensitivity setting for Mode 0, 1, 2, 5 and 6 is used for more accurate resolution
of the dog at motion/standstill.
S-1: Lowest sensitivity – assessment of standstill status may include dog's slight
movement.
S-9: High sensitivity – for assessment of standstill status dog must be at absolute
rest.
Setting the delay–
Setting the delay for Mode 0, 1, 2, 5 and 6 – the indication is activated when the
dog stays in the given state (motion/standstill) for the set time. The status indication
delay is also dependent on the set updating frequency (Paragraph 6.4, Page 11).
Updating
frequency [s]
Time (delay)
Indication delay [s]
The times given in the table are indicative.
/ to select the required value or mode. To return to the level
Indication
Motion
Beeper flashes Beeper flashes
-
-
-
-
Acoustic
Vibration
3
1 2 3 4
7 10 13 16
/ arrows and confirm by
Standstill
Acoustic
Vibration
Acoustic
Vibration
-
-
6
1 2 3 4
10 16 22 28
Type of hunt
-
Bird hunting
Bird hunting
Hunting wild boars
Hunting wild boars
-
-
9
1 2 3 4
11 20 29 38
.
21