Starting The Dishwasher - Ariston LI 641 A Mode D'emploi

Ready, steady, go!
You have loaded your dishes and you now have
to set the wash cycle. It takes just one minute
to learn how
First of all.
After performing all the operations
described in the previous para-
graphs, turn the water tap on com-
pletely, open the appliance door and
press ON-OFF button "A": indica-
tor light "B" comes on. Your appli-
ance is now on and awaiting in-
structions.
Selecting the wash
cycle.
Select the wash cycle by pressing
button "P". Each time this button
is pressed, one of the indicator
lights "M" will come on in sequence,
select the wash cycle you deem
most suitable for the type of dishes
to wash (take a look at page 17,
where you will find the wash cycle
table). Close the appliance door and
after a few seconds, you will hear
a short beep: the wash cycle has
begun.
Modifying a wash cycle in
progress.
But if you have chosen the wrong
cycle, not to worry! You can modify
the wash cycle in progress, if it has
only just started. Open the appli-
ance door carefully to avoid any
hot water splashes, then keep but-
ton "P" pressed for approximately
5 seconds, until you hear a short
beep. Indicator light "M" will come
off and at this point, all the settings
will have been cancelled. You are
now free to re-set the correct wash
cycle.
You can cancel
the wash cycle
in progress, if it
has only just
s t a r t e d .

Starting the dishwasher

You've left out a dish?
Well, it happens to everyone. Inter-
rupt the wash cycle by opening the
appliance door with the utmost
care, as usual, then insert the dish
you had forgotten. When you shut
the appliance door, the cycle will
start up from where you interrupted
it.
Finished?
The end of the wash cycle is indi-
cated by a double beep and the flash-
ing of the wash cycle indicator light
"M".
Warning!
Open the dishwasher door,
turn off by pressing button “A”,
unplug the appliance from the
electricity socket to cut off the
power supply; the power supply
cable should consequently be
easily accessible.
Turn off the water tap.
Wait a few minutes before unload-
ing the dishes: they are very hot! If
you wait a little while, they dry
better thanks to the steam.
Empty the lower rack first.
There's been a power fail-
ure? Have you opened the
dishwasher door?
The wash cycle stops and then re-
starts when the electricity comes
back on or when you shut the door.
Everything is under control!
Do you want extra
drying?
Press button "E" before you start
the selected wash cycle. A long
beep will tell you that you have
selected extra drying and the wash
cycle will last longer in order to
provide you with drier dishes.
Make sure the
wash cycle has
ended before
removing the
d i s h e s !
ARISTON DISHWASHER - Instructions for installation and use
D
1509)50-4
If opening the
door soon after
the end of the
p r o g r a m m e , o r
during it, stand
away from the
Dishwasher, to
avoid possible
injury from hot
s t e a m .
15