Manual Ignition; Connecting The Gas Cylinder To The Appliance - GRILL ME NEVADA Guide De L'utilisateur

2. Open the side burner lid before lighting the side burner and turn the side burner control knob to the
' OFF' position.
3. Push down the side burner control knob and keep pressing whilst turning anti-clockwise to the full
rate position, an audible click will be heard, this will light the burner. If the burner does not light,
repeat this process.
4. If the burner has not lit after two attempts, turn off the gas tap, wait 5 minutes and then repeat step
3 in main burner lighting instructions.
5. When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-
clockwise to any position between the full and low rate position.
6. To turn the barbecue 'OFF', turn the cylinder valve or regulator switch to the 'OFF' position and then
turn all of the control knobs on the appliance clockwise to the ' OFF' position when the flame have
extinguished.
Warning: If the burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve
off. Wait five minutes before attempting to relight with ignition sequence.

MANUAL IGNITION

If necessary this barbecue can be lit manually.
Main Burners
Open the lid before lighting.
Light a 90mm barbecue match and hold adjacent to light hold at the left end of the barbecue.
Turn the left burner control knob to the full rate position. The burner will light from the match.
Once the left burner is lit, the burner next to it can be turned on and will light off the lit burner.
Light remain burners from left to right by the cross-lighting channel.
When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-clockwise
to any position between the full and low rate position.
Side burner (If applicable):
1. Open the lid before lighting.
2. If igniter fails to spark, use a match to light burner.
After use, close the gas supply by either turning 'OFF' the switch on the regulator or turning 'OFF'
the cylinder valve.
In the event of light back whilst the appliance is in use. Turn all the controls, cylinder valve and regulator
switch to the 'OFF' position. Wait 5 minutes before attempting to relight the appliance. If the problem
persists after relighting, consult your gas dealer, or the store where you purchased the barbecue, or a
qualified gas engineer for assistance or repair. Never try to rectify the problem yourself as this could
result in serious injury and/or property damage.
The diameter of the pot should be around 180~220mm.
Clean the appliance of excess fat, before storage, with a damp cloth using a mild detergent solution as
the cleaning agent.
Store the appliance in a clean dry environment.
Do not store your gas cylinder indoors. Store in a well ventilated area away from direct sunlight

CONNECTING THE GAS CYLINDER TO THE APPLIANCE

This appliance is only suitable for use with low-pressure butane or propane gas and fitted with the
appropriate low-pressure regulator via a flexible hose. The hose should be secured to the regulator
and the appliance with hose clips/nut. This barbecue is set to operate a 28 mbar egulator with butane
4