Lighting Your Barbecue - GRILL ME NEVADA Guide De L'utilisateur

Any unauthorised modification of the appliance will invalidate the guarantee on this
appliance.
Never mount the cylinder under the barbecue on the base shelf as this could result in
serious injury to the user, other people and/or property.
The appliance must not have any overhead obstruction. E.g. trees, shrubs, lean to roofs. The appliance
must be installed with a clearance of 1 m around the appliance.
This appliance must be kept away from flammable materials during use. (Petroleum based products,
thinners or any other solid object that carries a flammable warning label.)
The use of this appliance in enclosed areas can be dangerous and is PROHIBITED.
INSTRUCTIONS FOR USE
Follow these instructions carefully to avoid seriously damaging your barbecue and causing injury to
yourself and to property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with the
regulator.
4. Turn all of the control knobs to the ' OFF' position before turning on the gas supply to the appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.

LIGHTING YOUR BARBECUE

Lighting Instructions: Main Burners
1. Open the lid before lighting.
2. Connect the gas cylinder to the barbecue following the instructions supplied with the regulator.
3. Turn all the control knobs to the ' OFF' position.
4. Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator connection and
operating instructions. Check the cylinder to regulator connection and hose to barbecue hose inlet
connection for leakage using soapy water. Any leakage will show as bubbles in the area of the leak.
If leak is found, do not use the barbecue. Consult your gas or barbecue supplier for advice.
5.To light the left hand burner, push down and turn the left burner control knob anti-clockwise to the
90° position (full rate position). An audible click will be heard, this should light the burner. Check that
the burner is alight. If the burner has not lit, repeat this process.
6. If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes before retrying
the ignition sequence.
7. When the burner has lit, the burner rate can be adjusted by push down and turn the knob anti-
clockwise to any position between the full and low rate position.
8. Light the remaining burners from left to right in sequence.
9. To turn 'OFF' the barbecue, turn the cylinder valve handle or regulator switch to the 'OFF' position by
following the regulator instructions. Once the burners have extinguished turn all the control knobs to
the ' OFF' position.
Warning: If any burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder
valve off. Wait five minutes before attempting to relight with ignition sequence.
Side burner lighting instructions (If applicable):
1. Once the grill burner has been lit, the side burner can be lit by following the instructions below.
3