Vikakoodit; Suojarakenteet, Laitteen Kaatumisen Varalta (Rops) - Gianni Ferrari PG 280 Notice Technique

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33

23. ViKAKoodit

ERROR POSITION
E R R O R
BUZZER
CODE
Initial test phase
E1 lamp.
E2 lamp.
E3 lamp.
E4 lamp.
Glow plug heating
E10
cycle
E11
E12
E14
Operating cycle
E20
E21
E22
E24
Temp.
Beeps
Lamp.
E30
very slow
beeps
E31
Slow beeps
Any phase
CC1
CC2
CC3

24. sUojArAKENtEEt, LAittEEN KAAtUMisEN VArALtA (roPs)

118
ALARM DESCRIPTION
The test on the pre-heating sensor
has detected a lower temperature than the
envisaged range.
The test on the pre-heating sensor
has detected a lower temperature than the
envisaged range.
The test on the water temperature sensor
has detected a higher temperature than
the the range.
The test on the water temperature sensor
has detected a lower temperature than
the range.
The safety test has found the PTO
activated.
The safety test has found the parking
brake is off.
The safety test has found the driver is
not in his seat.
The safety test has found the engine
compartment open.
The safety test has found the PTO
activated.
The safety test has found the parking
brake is off.
The safety test has found the man is not
in his seat.
The safety test has found the engine
compartment open.
The water temperature test has found that
the engine has exceeded the temperature
of 100° C.
The basket is full and the PTO activated.
The air filters is clogged.
There is a short circuit on the glow plug
heating output.
There is a short circuit on the engine
stop output
There is a short circuit on the buzzer
output.
POSIBLE CAUSES AND/OR
LENGTH OF SIGNAL
REMEDIES
The pre-heating sensor has
Until the error condition is
probably not been activated
removed.
correctly.
The pre-heating sensor has
Until the error condition is
probably not been activated
removed.
correctly.
The water temperature
Until the error condition is
sensor has probably not been
removed.
activated correctly.
The water temperature
Until the error condition is
sensor has probably not been
removed.
activated correctly.
Disconnect the PTO.
Until the error condition is
removed.
Apply the parking brake.
Until the error condition is
removed.
the driver must sit on
Until the error condition is
the seat.
removed.
Close the engine
Until the error condition is
compartment.
removed.
Disconnect the PTO.
Until the error condition is
removed and the engine
switched back on.
Apply the parking brake.
Until the error condition is
removed and the engine
switched back on.
Sit on the seat.
Until the error condition is
removed and the engine
switched back on.
Close the engine
Until the error condition is
compartment.
removed and the engine
switched back on.
Disengage the PTO and keep
Until temperature returns
motor at medium speed.
normal.
Until you quite the alarm
condition.
Until you quite the alarm
condition.
Check the glow plug heating
Until the error condition is
circuit.
removed and the engine
switched back on.
Check the engine circuit.
Until the error condition is
removed and the engine
switched back on.
Check the buzzer circuit.
Until the error condition is
removed and the engine
switched back on.
katso kuva 24.
ERROR
1
1
2
2
1
2
3
5
1
2
3
5
6
7
7
0
0
0

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sr 280

Table des Matières