Assembling The Clamp-Wire; Attaching The Toroidal Ferrite Core To The Power Cord Of The Subwoofer - Samsung HW-H7500 Mode D'emploi

INSTALLATION
ASSEMBLING THE CLAMP-
WIRE
Clamp-Wire
Attach the clamp-wire to the unit as shown, and then run
the cables through the clamp-wire to keep them neat.
ATTACHING THE TOROIDAL
FERRITE CORE TO THE
POWER CORD OF THE
SUBWOOFER
You can reduce noise caused by electromagnetic
radiation by fitting the ferrite core to the power cord of
your subwoofer.
1. Unlock and open the ferrite core.
2. Wind the power cable of your subwoofer around the
ferrite core twice.
(Start winding 5 to 10 cm away from the core).
3. Close the ferrite core by pressing it until it clicks.
14
I D S E T