Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation and operation
The following graphic shows the Audio Extractor connected in a typical set up, with HDMI/MHL cables
connected between the source equipment, Audio Extractor and HDMI display equipment. Additionally a
cable is connected between one or more of the Extractor's audio outputs and an AV receiver/amplifier.
HDMI Cable
MHL Cable
TOSLink / Phono Cable
Installation is simple, make sure that all devices are powered off and then connect the cables as
described above and then connect the provided power supply and power on all devices.
The Power LED will illuminate red when the power supply is connected, whilst the Status LED will only
illuminate green when a HDMI signal is received. Once playback commences sound is output through all
of the audio out interfaces simultaneously.
By default the extractor is set to advanced mode, this allows either multi-channel or stereo audio to be
input/output via the extractor. By pressing the Select button you can change this setting to stereo or
multi-channel only, this will affect the EDID data that is shown to your HDMI source device and so the
screen may flash on/off briefly whilst handshaking occurs.
For installations using multiple HDMI sources, position the Audio Extractor between a HDMI switch and
HDMI display equipment. Installations using multiple HDMI displays require the Audio Extractor to be
positioned before a HDMI splitter.
ARC Mode
The Audio Extractor can also be used to send audio from a DVB-T or DVB-S signal from your TV's
internal tuner to your AV Receiver via an ARC enabled HDMI port.
To use the Audio Extractor in ARC Mode, make sure that the Extractor is connected to a HDMI port on
your HDMI TV which supports the ARC function and that a TOSLINK cable is connected between the
Extractor and your AV Receiver. Press the ARC Select button on the front of the Extractor, the ARC LED
will then illuminate green and the audio signal will be sent to your AV Receiver. To switch back to
standard mode press the ARC Select button again, the ARC LED will then switch off and the Extractor is
now
set
back
to
English
or
or
Standard
mode.
Publicité
