Making An Espresso - Electrolux EEA150 Mode D'emploi

822 949 402_EEA150.book Seite 30 Freitag, 18. Januar 2008 7:44 19
g
• Do not use the appliance without the
drip tray or the drip grating.
Safety during cleaning
• Prior to maintenance or cleaning
ensure that the appliance has been
switched off and that the power plug
has been disconnected.
• Follow the instructions referring to
decalcification.
• Do not immerse the appliance in water.
Safety during repairs
Repairs to this appliance may only be
carried out by qualified service
engineers. Considerable danger may
result from improper repairs. If repairs
become necessary, please contact the
Customer Care Department or your
authorised dealer.
If the appliance is used for purposes
other than those for what it was
intended or is operated wrongly, no
liability for possible damages can be
accepted.
This appliance conforms with the fol-
;
lowing EC Directives:
• Low Voltage Directive 2006/95/EC
• EMC Directive 89/336/EEC with
amendments 92/31/EEC and
93/68/EEC
Prior to using the appliance for
the first time
Please read the safety instructions in
order to prevent danger to yourself
and damage to the appliance.
0 Insert the power plug into the power
outlet.
Prior to preparing an espresso for the
first time you should rinse out the
heating system once by filling the tank.
Proceed exactly as described in the
section "Making an espresso" and
"Frothing milk", but without placing
any ground coffee in the filter. Place a
container that is as large as possible in
the middle of the drip grating
30
(figure 1/T) and under the steam
nozzle (figure 1/H).

Making an espresso

After having been brewed, the espresso
should be covered with a dense frothy
layer, the so-called crema.
To achieve an aromatic espresso with
crema, fresh, clear water, the correct
size grounds and the water
temperature are important.
1. Adding water (Figure 2)
0 Pull the water tank upwards and out of
the appliance (figure 2).
0 Open the tank lid.
0 Fill the water tank with cold, clear
water only.
Ensure that the water line does not lie
below the MIN (minimum) line or
above the MAX (maximum) line.
0 Close the tank lid.
0 Replace the water tank and press it
downwards so that it is sitting firmly in
the appliance (figure 2).
3 You can also lift the tank lid and fold it
to the side. This enables you to fill the
water tank directly when it is in the
appliance, e.g. with a jug.
2. Switching on the appliance /
preheating cups
0 Switch the appliance on using the on/
off switch (figure 1/A). The power
indicator (figure 1/C, red) and the
temperature indicator (figure 1/D,
orange) will illuminate.
As soon as the operating temperature
has been attained, the temperature
indicator will go out. The temperature
indicator may illuminate again while
the appliance is being used to indicate
that the appliance is re-heating.
You can place one or more cups with
the opening facing downwards on the
cup storage area (figure 1/E).