Check Installation; Reset Procedure - rialto ZED-TTR2-RI Manuel D'installation

Check installation

17. Check that the t
"Home" page of the App.
18. Use the + or - buttons until a flame
t
heRmoStat
check the connections and/or the wiring between the t
the boiler.

Reset Procedure

1. Press and hold the + and - buttons simultaneously until the message
EN
"PRo" appears in the display
2. Press the + button repeatedly until the letters "RST" appear above the
"PRo" message, then wait; the thermostat will revert automatically to
the screen displaying ambient temperature.
3. Press and hold the + and - buttons simultaneously until the message
"PRo" appears in the display
4. Press the + button repeatedly until the letters "LEA" appear above the
"PRo" message, then wait
5. If the control signal was sent correctly, the thermostat will display the
feed back message "YES" and restart
6. The Reset procedure is now complete; the Thermostat displays the
message "no Net".
heRmoStat
. In this condition the heating should be in operation; if not,
is included in the list of devices on the
appears in the display of the
| 22 |
and
heRmoStat