Electrical Connection - Caso Germany TG 300 Mode D'emploi

12.6 Electrical connection

caso Tischgrill 300
• Do not set up the device in a hot, wet or extremely damp
environment or near flammable material.
• To operate correctly, the appliance requires a sufficient flow
of air. Leave a 15 cm gap on all sides when setting up the
appliance.
• The electrical socket must be easily accessible so that the
power lead can be disconnected easily, in the case of an
emergency.
• The installation and assembly of this device in non-stationary
setup locations (e.g. on ships) must be carried out by specialist
companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
In order to ensure the safe and trouble-free operation of the
device, the following instructions must be observed for the
electrical connection:
• Before connecting the device, compare the connection data
(voltage and frequency) on the rating plate with those of your
electrical network. This data must agree in order that no
damages occur in the device.
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out
switch.
• The connection between the device and the electrical network
may employ a 3 meter long (max.) extension cable with a
cross-section of 1.5 mm². The use of multiple plugs or gangs
is prohibited because of the danger of fire that is involved with
this.
• Make sure that the power cable is undamaged and has not
been installed under the oven or over hot or sharp surfaces.
The electrical safety of the device is only guaranteed if the
device is connected to a properly installed protective
conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt,
have the house installation checked over by a qualified
electrician.
The manufacturer cannot be made responsible for damages
that are caused by a missing or damaged protective
conductor.
Commissioning
34