Items Supplied; Before Using For The First Time; Remote Control; Setting Up The Device - SilverCrest SSBS 36 A1 Mode D'emploi

BB72=  B6RXQGEDVHB%ERRN 6HLWH  'LHQVWDJ  -XOL    

4. Items supplied

1 soundbase
1 power unit|12
1

remote control

1 CR2025 3 V battery (inserted)
1 stereo cinch cable|13
1 copy of the user instructions
• Remove all packing material.
• Check that the device is undamaged.
In the case of incomplete delivery, please contact the re-
sponsible service centre of the manufacturer (see "Warran-
ty of the HOYER Handel GmbH" on page 19).
Please observe the illustrations on the fold-out page.

5. Before using for the first time

5.1 Remote control
Initial use
• Remove the transport lock from the battery compart-
ment and remote control.
Changing the battery
DANGER OF EXPLOSION! If the battery is not
correctly replaced. Replace only with the same or
an equivalent type.
1. FIGURE A: open the battery compartment cover by
unlocking it and sliding it in the direction of the arrow.
2. Replace the old battery with a new one.
WARNING! Ensure the correct polarity of the bat-
tery. The plus symbol on the battery must be visi-
ble.
3. Close the battery compartment again.

5.2 Setting up the device

CAUTION:
~ Do not place television sets or other devices that are
heavier than 45kg on the soundbase.
~ Figure B: always place other devices centrally on the
soundbase so that they will not fall.
• Remove all parts of the packaging completely.
• Do not expose the device to extreme heat or moisture.
Ensure that the device is well ventilated on all sides.
1. Place the device on a level surface.
2. Connect the power unit|12 to the device.
3. Decide where to place the soundbase. Always make
sure that ...
- there is a wall socket nearby;
- there is enough space above, in case you want to
place a television set on the device;
- a television set and any other devices (e.g. set-top
box, DVD player) can be set up nearby, in case you
do not want/are unable to place them on the device.
4. Connect the source device(s). Always ensure that all
devices are securely positioned.
5.3 Overview – Connections
CAUTION: make sure that the soundbase and the devices
to be connected are switched off before you connect them.
Please also read the user instructions for the devices which
you are connecting.
NOTE: the HDMI (ARC)|10 connection is only able to
function if all components are ARC-enabled. If necessary,
old HDMI cables must be replaced with new ARC-enabled
ones.
Input Use
Connection with ste-
reo cinch cable|13,
AUX IN|8
e.g. television set,
CD player
Connection with 3.5
mm stereo jack ca-
LINE IN|6
ble, e.g. MP3 play-
er, telephone
Connection with
HDMI (ARC) cable,
HDMI e. g. to the HDMI-
(ARC)|10 ARC connection of
the television set, DVD
player
Connection with opti-
cal cable (also called
Toslink) to the optical
OPTICAL output of the televi-
IN|11
sion set or DVD play-
er. Before connecting
remove the connec-
tion's protective cap.
Radio connection,
Bluetooth
e.g. smartphone
• A subwoofer can be connected to the cinch socket of
the SUB OUT|7 output. This is automatically con-
trolled by the device.
Remote
LED
control but-
colour
ton
AUX|18
white
LINE IN|28 green
HDMI
yellow
(ARC)|17
OPTICAL|19 purple
|15 blue
GB 15