WOLFF VARIO-STRIPPER 230 V/50 Hz Traduction Du Mode D'emploi Original page 18

EN
The A-rated sound pressure level of the machine is
normally
Sound pressure level .....................dB(A)
Sound power level..........................dB(A)
Margin of error ...............................K=dB
Attention
Overall vibration values
(vector sum of three directions)
determined in accordance with EN 60745:
Vibration emission level ..................ah =
Margin of error ..................................K =
3.0 Preparing the machine
3.1 Installing additional weights fig. I+J
The base weight of the VARIO-STRIPPER SILENT is as
low as possible for easy handling and transport.
To be able to work efficiently, the machine comes with an
additional weight. Insert additional weight into the supports
and tighten with the wing nuts.
3.2 Installation Handel fig. E
► Put the handle into the bracket and fix wit bolts and
thumb nut (3).
► Connect the plug of motor and handle.
► Disasamble in other direction.
3.3 Adjusting the handle angle fig. E
The angle oft the handle can be fixed into 4 position.
Loosen and remover bolt (3) and choose one of the 4
position to your comfortable angle.
3.4 Adjusting the handle height fig. E
The height of the handle can be adjusted to adapt the ma-
chine to the stature of the operator. To adjust the inclina-
tion, loosen the thumb screw (1), pull the adjustment bolt
(2) and adjust as you like. Thighten the thumb screw (1)
after adjustment.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 7062-91556-0 | Fax: +49 7062-91556-41 | www.wolff-tools.de
18 18
Wear hearing protection!
3.5 Changing the blade fig. B
► Disconnect the power supply before changing the
70
blade.
83
+/- 1.5 dB
► To insert the knives it is recommended to wear protecti-
ve gloves.
Attention
► knives become very hot when working, do not touch
them before they have cooled down.
3.3 m/s²
► Tilt the machine on the footrest, raise the handle first.
+/- 1.5 m/s²
► The knife is not pre-assembled for safety reasons.
► Attach supplied knife guard! (located in the toolkit)
► Without knife guard there is a risk of injury as the knife
is very sharp!
► Clean and loosen nuts 2 in Fig B.
On normal and hard subfloors the bevel of the blade
should show upwards fig.C (1), on soft subfloors
(e.g. chipboards) the bevel should show downwards (2).
► Insert the blade according to the ground between the
adapter plate (6) and the deflector (1).
► When inserting the new knife, make sure that the knife
rests firmly against the supporting edge.
► Tighten nuts.
4.0 Use
4.1 Preparations fig. G
The VARIO-STRIPPER removes any bonded floor
coverings in stripes.
► Before starting work, cut the floor covering into
stripes of about 25 cm (9,8 inch).
► You cannot work faster if you cut wider stripes.
► To begin, cut one stripe crosswise. Then lift the floor
slightly in order to get the blade underneath it.
► We recommend to cut the first strip at right angles to