Safety Instructions; Personnel Qualification And Training; Dangers In Case Of Non-Compliance With The Safety Instructions; Safety Conscious Working - Sera MU- 300 E 187.2 Mode D'emploi

Electric agitator
MU-037300 E 187.2
MU-055450 E 114.2 / MU-075550 E 094.2
Operating instructions

2. Safety instructions

2.1 Personnel qualification and training

The personnel who operate, service, check and install the system must be suitably qualified. The range of respon-
sibility and the supervision of the personnel are to be clearly defined by the owner. If the personnel do not have the
required knowledge, they need to be trained and instructed accordingly. If required, such a training can be carried
out by the manufacturer / supplier of the electric agitator by order of the owner. The owner must also ensure that the
personnel have understood the content of the operating instructions.

2.2 Dangers in case of non-compliance with the safety instructions

Inobservance of these safety instructions can result in danger to persons, hazards to the environment and damage
to the electric agitator.
For example, non-compliance can result in:
Failure of important functions of the electric agitator.
■
Failure of required maintenance and service methods.
■
Danger to people through electrical, mechanical and chemical influences.
■
Hazards to the environment by leaking dangerous substances.
■

2.3 Safety conscious working

The safety instructions specified in this operating manual, the national regulations for accident prevention, the
safety regulations for the pumped medium applicable at the place of installation as well as internal working-, operat-
ing-, and safety instructions of the owner must be observed.

2.4 Safety instructions for the owner / operator

If dangerous transported materials and operating fluids leak in the event of a fault, they have to be discharged in a
way that does not cause harm to people and the environment. The legal regulations are to be observed
Dangers caused by electric energy must be ruled out.

2.5 Safety instructions for maintenance, inspection and installation work

The owner must ensure that all maintenance, inspection and installation work is carried out only by authorized and
qualified personnel who have read the operating instructions carefully.
34
www.sera-web.com Subject to technical modifications!
TA 504 Vers. 3 en 11/2021