ready2music Chronos Air Pro Mode D'emploi page 10

Battery Info
This device is equipped with an integrated lithium
polymer battery. The battery cannot be replaced. Do
not attempt to remove the battery from the device as it
may affect the performance of the device.
Complete performance cannot be achieved unless the battery is
fully charged and discharged at least 2-3 times. The battery has
a very long life and can be charged and discharged hundreds of
times. In the long run, however, a loss of capacity is unavoidable,
as with any other battery.
Remove the cable as soon as the battery is fully charged.
Permanent overcharging of the device may affect the battery life.
A fully charged battery slowly loses capacity when not in use.
IMPORTANT:
Make sure that the battery is fully charged if you will not use
the device for a long time. To avoid completely discharging the
battery, the device should be charged at least every 6 months.
Do not dispose this product into houshold waste. For
environmentally responsible recovery, recycling and
treatment of the product, contact your local authority
for details of your nearest designated collection
point. (More on Page 25)
Attention: Only use power supplies that are suitable
and approved for your mains supply. Observe the
written input and output power.
18
Charging
The charging station and both earphones are equipped with
separate rechargeable batteries. Fully charge the batteries
before first use.
Earphone Charging
• Please recharge the headphones as soon as the red light
flashes once every 10 seconds and „Battery Low" sounds
every 2 minutes.
• To charge the earphones, make sure that the charging pins are
clean and dry. Then put the earphones into the charging case.
The Indicator lights will activate accordingly and will light up in
a „breathing" motion during the whole charging process.
Info: It takes approximately 2 hours to fully charge the earphones.
The Indicator lights will turn off, as soon as the earphones are
fully charged.
Case Charging
• Please recharge the case as soon as the four case indicator
lights are flashing 3 times every 1 minute.
• To charge the case, connect the provided USB cable to a
suitable USB output.
Info: During the charging process, the 4 indicator lights will show
the charge state as the first (25% charge), second (50% charge), third
(75% charge), and fourth (fully charged) indicator is flashing
Info: If the charging case runs out of power, the earphones will start
automatically.
Info: Opening the cover of the charging case will start the earphones.
EN
19