Italkero Falo Evo Instructions D'installation Et D'utilisation page 30

troUBleShootinG: with remote control.
No flame
When ignited the appliance does not work,
The POWER indicator does not come on.
No spark when the appliance is started.
Spark ok but pilot flame does not come on.
Pilot flame on, sparks continue without stop
(no flame detection).
Pilot flame on, the main burner does not
come on.
The low flame comes on; the medium flame
does not.
The medium flame comes on; the low flame
does not.
During the ignition cycles, the appliance does
not go off in 25 seconds.
The remote control battery is down.
Blackening of glass pipe
Glass pipe breakage
UK
FAULT CAUSE
1-Not enough gas supply (bad LPG gasification
or dirt in system) or pressure regulator not set
properly or faulty.
2-No gas flow (tank empty or interruption in
supply) or pressure regulator faulty.
3-Sudden gust of wind (above 3 m/s) with
gas tank panels removed.
4-Dirt in gas circuit.
5-Gas leaks.
6-cylinder connection, air in pipe
1-Battery charge too low, battery pack
faulty (B1) or poles loose.
2-Infra-red receiver (D) covered.
3-The POWER button of the remote control
has not been pressed for 2 seconds.
4-Remote control faulty or batteries low.
5-Connection cables between front and
rear control boards loose or faulty.
6-Control boards faulty.
7-Dump-switch failure or the floor with
inclination greater than 15¡.
1-Distance between the ignition device
(HV1) and the earth connection or the distance
between the electrodes (HD) is excessive.
2-The ceramic part of the ignition device (HV1)
is broken or faulty.
3-High-voltage cable loose, broken or short-
circuited.
4-No earth connection in pilot set.
5-Rear control board faulty.
1-No gas supply.
2-Connection faulty between front and rear
connection boards or power cables loose.
3-Pilot injector blocked.
4-Rear control board faulty.
5-Valves G1 and G2 faulty.
1-Flame sensor cables (S) and ignition device
(HV) switched over or loose.
2-Flame sensor (S1) and earth short circuited.
3-Flame sensor (S1) fails to detect flame.
4-Pilot flame burns inside pilot pipe.
5-Rear control board faulty.
1-Cables faulty or terminals loosened.
2-Main burner nozzle blocked.
3-ÒMÓ and ÒLÓ valves faulty.
4-Front and rear control boards faulty.
5-Faulty remote control.
1-Cables faulty or terminals loose.
2-ÒMÓ valve faulty or ÒMÓ valve nozzle
blocked.
3-Front control board faulty.
4-Faulty remote control.
1-Cables faulty or terminals loose.
2-ÒLÓ valve faulty or ÒLÓ valve nozzle blocked.
3-Front control board faulty.
4-Remote control faulty.
1-Front control board faulty.
1-The battery is failing.
1-poor quality gas or gas unsuitable for winter
2-bad draught.
3-mains cylinder (optional) out of
position/deformed.
4-exchanger head dirty/damaged.
5-burner dirty/damaged.
- excessive thermal shock due to particular
weather conditions.
- cleaning with unsuitable instruments.
- accidental fall of appliance.
30
REMEDY
1-Clean, set / replace.
2-Check / replace.
3-Replace panels.
4-Check / clean.
5-Check/tighten connections/replace seals or pipes.
6-repeat ignition to eliminate air.
1-Replace batteries, tighten poles
2-Make hole for receiver.
3-Press POWER for 2 seconds, release and
press again.
4-Replace Remote Control or Batteries
5-Remedy or replace.
6-Replace.
7-Replace, change position (floor with
inclination less than 15¡).
1-Regulate the distance to 4 __0.5 mm.
(The cable resistance must be connected close
to the ignition device).
2-Replace the ceramic part.
3-Repair or replace.
4-Make earth connection.
5-Replace.
1-Check.
2-Reposition or replace cables.
3-Check or replace.
Nozzle diameter: LPG: 0.35 mm; NATURAL
GAS: 0.55 mm.
4-Replace.
5-Replace.
1-Put right.
2-Restore correct position.
3-Restore correct position.
4-Replace.
5-Replace.
1-Repair or replace.
2-Check gas pressure, replace pilot set or
perforate injector again.
3-Check gas pressure, replace ÒMÓ and ÒLÓ
valves.
4-Replace.
5-Replace.
1-Repair or replace.
2-Replace.
3-Replace.
4-Replace.
1-Repair or replace.
2-Replace.
3-Replace.
4-Replace.
1-Replace.
1-Replace.
1-use quality gas, preferably pure propane.
2-particularly windy or no wind-protection KIT.
3-reposition/replace/eliminate.
4-clean/replace.
5-clean/replace.
- Replace.
- Replace.
- Replace.