Connect Power - Durabase 24F114X2 Mode D'emploi

through the available sources by pushing the button
up or down.
To turn the TV off: Press the middle of the button down
and hold it down for a few seconds, the TV will turn
into standby mode.
Inserting the Batteries into the Remote
Lift the cover on the back of the remote upward gently.
Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity) Replace the cover.

Connect Power

IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable Connection
Connect the "aerial" or "cable TV" plug to the AERIAL
INPUT (ANT) socket located on the back of the TV.
Manufactured under license from Dolby Laboratories.
TRADEMARK ACKNOWLEDGMENT
"Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.
Interface are trademarks or
registered trademarks of HDMI
Licensing LLC."
Notification
"HDMI, the HDMI logo and High-Definition Multimedia
Information for Users on Disposal of Old
Equipment and Batteries
[European Union only]
These symbols indicate that equipment with these
symbols should not be disposed of as general
household waste. If you want to dispose of the product
or battery, please consider the collection systems or
facilities for appropriate recycling.
Operation
temperature and
operation humidity:
English - 19 -
Notice: The sign Pb below the symbol for batteries indicates
that this battery contains lead.
TV Broadcasting
Receiving Channels
Number of Preset
Channels
Channel Indicator
RF Aerial Input
Operating Voltage
Audio
Audio Output Power
(WRMS.) (10% THD)
Power Consumption
Weight
TV Dimensions DxLxH
(with foot)
TV Dimensions DxLxH
(without foot)
Specification
5ºC up to 45ºC, 85%
humidity max
45 W
3,80
134 x 569 x 384
35 x 569 x 355
Battery
Products
PAL B/G D/K K
VHF (BAND I/III) - UHF
(BAND U) - HYPERBAND
1000
On Screen Display
75 Ohm (unbalanced)
220-240V AC, 50Hz.
German+Nicam Stereo
2 x 2,5