Installing The Batteries To The Remote; Connect Power & Antenna/Cable; Switching On/Off; To Switch The Tv On - Durabase DB32LE112 Mode D'emploi

Installing the Batteries to the Remote

1. Lift the cover on the back of the remote upward
gently.
2. Install two AAA batteries. Make sure to match the +
and - ends of the batteries in the battery compartment
(observe the correct polarity.
3. Replace the cover.
Connect Power & Antenna/Cable
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.

Switching On/Off

To Switch the TV On

Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button on
the remote control.
Press the control switch located on the left side of the
TV. The TV will then switch on.

To Switch the TV Off

Press the " " button on the remote control or press and
hold the control switch on the TV until the TV shuts
down, so the TV will switch to standby model.
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active. The LED can also blink
when you switch on the TV from standby mode.

First Time Installation

When turned on for the irst time, the "language
selection" menu appears. The message "Welcome
please select your language!" is displayed in all
language options listed alphabetically.
Press the "
language, press OK button to select. "First Time
Installation" appears. Use "
required country, and press "
Type (optional). Use " " or " " to set the desired search
type. Available search types are Digital and analog,
digital only and analog only. When set, press "
select Teletext Language. Use "
set the "Teletext Language" and select "Scan Encrypted"
using " " or "
as Yes if you want to scan coded stations.
Press OK button on the remote control to continue and
the following message will be displayed on the screen.
You can activate Store mode (optional) option by
using " " or "
is selected, Store mode option will be available
in other settings menu and your TV's features
English - 30 -
" or " " button to highlight the required
" or "
" button to select Search
" or "
" button. You can set Scan Encrypted
" button. If Store Mode (optional)
" button to set the
" to
" button to