Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
notice_CT3000
22/11/06
17:39
Page 9
2: Assembly to the heating element
Remove all of the parts from the box and place them so that they are within reach during the assembly.
(as shown below).
The electrical cable attached to the heating element must be inserted through the inside of the tube
section corresponding to the heating element. The heating element must be turned over and remain
stable. Gently turn the tube in its setting on the heating element without
attaching it for the time being.
3: Base Assembly
As indicated in the figure below, pass the electrical cable from the base inside the tube section (corre-
sponding to the base). Turn the base over. It must remain stable. Turn the tube in its setting. Tighten it,
but do not attach it yet.
9
Publicité
Table des Matières
