ALPATEC CT 3000 Mode D'emploi page 11

notice_CT3000 22/11/06
- The switch is located under the base of the device:
- O .... Off
- I .... On
1. Assemble the device as described above.
2. Plug it into a waterproof outlet after having verified that the voltage corresponds to the
indicated voltage.
3. Press the On button.
1. Turn the device off and unplug it. If the device was on before cleaning, wait until it has
cooled down so you do not burn yourself.
2. With a soft cloth, carefully clean the device. Never use alcohol, solvents or acids such
as vinegar or abrasives.
Issues
The device will not
turn on.
The device does not
work, but the current
passes through.
The device functions,
then suddenly stops
functioning.
Model
Voltage
Power
17:39 Page 11
OPERA TIONS
OPERA TIONS
MAINTENANCE
MAINTENANCE
TROUBLESHOOTING
TROUBLESHOOTING
Potential causes
The device is not
plugged in properly.
The plug is defective.
An object is preventing the
On/Off button from working
properly.
Verify your electrical
power system/fuse/circuit
breaker.
SPECIFICA TIONS
SPECIFICA TIONS
CT 3000
230 V – 50 Hz
3000 W
11
Solutions
Remove the plug and plug
it in again properly.
Have it replaced by an
electrician.
Place it on a flat and stable
service. Look for the object
to be removed.
Have it checked by an
electrician.