Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5 Technical data
EN
Floor grinding machine DSM 430
5 Technical data
Designation
Rated voltage
Rated frequency
Rated current
Rated power
Connecting cable
5 x min. 2.5 mm
5 x min. 4.0 mm
Operating hours
counter
Tool-Speed
Protection rating
Dust extraction
Tank capacity
Dimensions
(LxWxH)
Operation
Transport
Working width
Edge distance
Grinding wheel
Grinding pressure
with additional
ith dditi
l
weights (optional)
Weight
Noise level
Vibration total value*)
*) determined under standardised manufacturer ope-
ration conditions according to measuring method
HARM.
6 Acceptance and transportation
Follow the safety instructions in Chapter 2.
6.1 Machine acceptance
The packaged machine is supplied complete from the
manufacturer.
1.
Unpack machine and check the delivery slip to
make sure all parts are delivered.
2.
Check for any transportation damage.
3.
In case of damage, contact the transport com-
pany promptly.
4.
Report any problems to the manufacturer imme-
diately.
Complaints at a later date cannot be acknowled-
ged!
20
Value
Unit
230 V, 1∼
50/60 Hz
8,4 A
2.2 kW
2
(max. 25 m)
2
(>25 m)
available
0 ... 1200 rpm
IP 23
∅ 50 mm
about 8 litres
about
1180 x 470 x 990
mm
800 x 470 x 920
mm
∅ 430 mm
min. 10 mm
3 x ∅ 100 mm
70 kg
95 kg
100 kg
79 dB(A)
2
± 2.5 m/s
6.2 Transporting the machine
Risk of injury from heavy parts!
Suspended loads can fall or tip over, causing
serious injuries!
Do not stand under suspended loads!
Raising and lowering the load must be perfor-
med by two persons!
Do not raise loads any higher than necessary!
Prevent the load from swinging back and
forth!
Keep sufficient safety distance.
Devices for stopping and transporting the
unit have to be rated to handle its full weight
and dimensions.
Observe weight data on packaging or in the
accompanying documentation.
Never walk or reach beneath the load while
it is being lowered.
Wear safety shoes!
Wear safety gloves!
Proceed with the greatest care and caution!
For longer transports or longer storage, the
machine needs to be covered to protect
against soiling.
For transporting, the machine can be taken apart into
2 pieces. A relocation over shorter distances is possi-
ble on the transport wheels.
1.
Decommission the machine (
2.
Either
a.
Fasten all loose parts to the frame.
b.
Move the machine to the respective loca-
tion with the transport wheels [4, Fig. A]
and deposit.
or
a.
Unplug the plug connection [18, Fig. G],
water connection [16, Fig. F] and if neces-
sary connection to the dust extrac-
tion [17, Fig. F].
b.
Loosen the 4 screws [20, Fig. H] as far as
possible without removing, so that the bolts
[21, Fig. I] are movable.
Chapter 4.8)
Publicité
Chapitres
Table des Matières
