Before Initial Use; Set-Up And Connection; Use - gourmetmaxx CM-111 Mode D'emploi

Before Initial Use

1. Remove all packaging materials and any possible protective fi lms used for protection
during transportation. Never remove the rating plate and any possible warnings.
2. Wipe down the device with a clean, damp cloth. Clean the permanent fi lter, the fi lter
holder and the coffee cup with mild detergent and warm water.
3. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run to
remove any possible production residues in the water system. To do this, follow the
instructions in the "Set-Up and Connection" and "Use" chapters.
When the device is fi rst used, production-related additives (e.g. grease) may
cause a small amount of smoke and / or an odour to be produced. This is normal
and not a device defect.
4. Perform this process twice. Do not drink this coffee!

Set-Up and Connection

PLEASE NOTE!
■ Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
■ The surfaces of furniture may possibly contain elements which can attack and soften
the adjustable feet of the device. If necessary, place a suitable pad below the adjust-
able feet.
1. Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is re-
sistant to splashing.
2. Completely unwind the mains cable and plug into a properly installed plug socket that
is easily accessible.

Use

PLEASE NOTE!
■ Do not pour milk or other liquids into the water tank. Only ever use water to make
coffee!
■ Never overfi ll the permanent fi lter.
■ Never operate the device without a suitable vessel placed below the coffee outlet.
The device switches off automatically after the brewing process. It has overheat-
ing protection which prevents the device from being switched on again directly
after a brewing process for safety reasons. After a brewing process, you should
therefore wait for a few minutes until the device has cooled down before you start
another brewing process.
1. Open the water tank cover and pour water into the water tank.
2. Insert the fi lter holder into the fi lter compartment.
3. Insert the permanent fi lter into the fi lter holder.
17 EN