Glass Guard Installation / Removal - Napoleon Luxuria Serie Manuel D'installation

fi nishing
EN

12.6 glass guard installation / removal

WARNING
!
• The polystyrene / styrofoam packaging materials may scratch the glass if the GGA-1 is not covered by the
plastic layer.
• Adequate steps must be taken to protect the appliance and Dynamic Heat Control™ (DHC) openings from
dirt, debris and damage during fi nishing.
• The GGA-1 installation and/or removal will require 2 people.
• The GGA-1 should be preliminarily fi tted and adjusted before fi nish framing and fi nishing the appliance. It is
much easier to make adjustments with the appliance pre-fi nishing access panel removed. It is recommended
that the GGA-1 is removed after preliminary adjustment and stored safely in the original packaging whilst
fi nishing is complete. Take precautions to protect the appliance during fi nishing.
Rear view of GGA-1
THIS WAY UP
Access side view of appliance
66
W415-2035 / C / 04.30.21
Key Components
• Outer glass
• Horizontal tab
• Napoleon logo
(affi xed to
intermediate glass)
• GGA-1 catch
• GGA-1 catch
securing screws
• Intermediate glass
• GGA-1 mount
bracket
Fig. 1
• Latch
• GGA-1 slider bracket
Fig. 2