Installation Of Batteries; Handling The Remote Control; Remote Control Operation Range - Krüger & Matz KM1584CD Mode D'emploi

Installation of Batteries

1. Open the battery compartment.
2. Insert 2 AAA batteries with correct polarity (+/-) as indicated.
3. Close the battery compartment.

Handling the Remote Control

• Remove the batteries if the remote control is not going to be used for an extended period of time.
• To avoid possible failure, read the following instructions and handle the remote control properly.
• Do not drop or cause impact to the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under the direct sunlight or near sources of excessive heat.
• Do not use caustic cleaners (porcelain, stainless steel, toilet, or oven cleaner etc.) on the
remote, as it may suffer damage.
Note:
Remove the battery from remote control handset when it is not to be used for a long period.
Otherwise it can be damaged due to leakage of battery.

Remote Control Operation Range

Point the remote control to the unit no more than 5
meters from the remote control sensor and within
30° horizontally and 30° vertically of the front of the
unit. The operating distance may vary according to
the brightness of the room.
Note:
• Make sure that there is no obstacle between
the infrared remote sensor of the unit and
remote control. If you install the unit on rack,
etc.., the remote controllable range may
decrease depending on the thickness or colour
of glass door of rack.
• Do not expose the infrared remote sensor to
direct sunlight or other strong light, such as
inverter fluorescent light.
28
Owner's manual