Regulatory Compliance - Clarity XL50 Guide D'utilisation

REGULATORY COMPLIANCE

Part 68 of FCC Rules
Information
a) This equipment complies with Part 68
of the FCC rules and the requirements
adopted by the ACTA. On the bottom
of this equipment is a label that
contains, among other information,
a product identifier in the format
US:AAAEQ##TXXXX. If requested,
this number must be provided to the
telephone company.
b) A plug and jack used to connect this
equipment to the premises wiring and
telephone network must comply with
the applicable FCC Part 68 rules and
requirements adopted by the ACTA. A
compliant telephone cord and modular
plug, RJ11C USOC, is provided with this
product. It is designed to be connected
to a compatible modular jack that is also
compliant. See installation instructions
for details.
c) The REN is used to determine the
number of devices that may be con-
nected to a telephone line. Excessive
RENs on a telephone line may result in
the devices not ringing in response to an
incoming call. In most but not all areas,
the sum of RENs should not exceed
five (5.0). To be certain of the number
of devices that may be connected to a
line, as determined by the total RENs,
contact the local telephone company.
For products approved after July 23,
2001, the REN for this pro-duct is part
of the product identifier that has the
format US:AAAEQ##TXXXX.
The digits represented by ## are the
REN without a decimal point (e.g., 03 is
30
a REN of 0.3). For earlier products, the
REN is separately shown on the label.
d) If this telephone equipment causes
harm to the telephone network, the
telephone company will notify you in
advance that temporary discontinuance
of service may be required. But if
advance notice isn't practical, the
telephone company will notify the
customer as soon as possible. Also, you
will be advised of your right to file a
complaint with the FCC if you believe
it is necessary.
e) The telephone company may make
changes in its facilities, equipment,
operations or procedures that could
affect the operation of the equipment.
If this happens the telephone company
will provide advance notice in order for
you to make necessary modifications to
maintain uninterrupted service.
f) If trouble is experienced with this
telephone equipment, for repair or
warranty information, please contact
Clarity, 800-426-3738. If the equipment
is causing harm to the telephone
network, the telephone company
may request that you disconnect the
equipment until the problem is resolved.
g) This telephone equipment is not
intended to be repaired and it contains
no repairable parts. Opening the
equipment or any attempt to perform
repairs will void the warranty. For
service or repairs, call 800-426-3738.
h) Connection to party line service is
subject to state tariffs. Contact the state
public utility commission, public service
REGULATORY COMPLIANCE
commission or corporation commission
for information.
i) If your home has specially wired alarm
equipment connected to the telephone
line, ensure the installation of this tele-
phone equipment does not disable your
alarm equipment. If you have questions
about what will disable alarm equipment,
consult your telephone company or a
qualified installer.
j) This telephone equipment is hearing
aid compatible.
Customer-Owned Coin/Credit
Card Phones
To comply with state tariffs, the
telephone company must be given
notification prior to connection. In
some states, the state public utility
commission, public service commission
or corporation commission must give
prior approval of connection.
Part 15 of FCC Rules
Information
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Your equipment has been tested and
found tocomply with the limits of a
Class B digital device, pursuant to
Part 15 of FCC rules. These limits
are designed to provide reasonable
protection against harmful interference
in residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation; if this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, you are encouraged to try
to correct the interference by one of
the following measures:
1. Where it can be done safely,
reorient the receiving television
or radio antenna.
2. To the extent possible, relocate
the television, radio or other
receiver with respect to the
telephone equipment. (This
increases the separation between
the telephone equipment and
the receiver.)
3. Connect the telephone
equipment into an outlet on a
circuit different from that to
which the television, radio, or
other receiver is connected.
4. Consult the dealer or an
experienced Radio/TV Technician
for help.
CAUTION: Changes or modifications
not expressly approved by the
manufacturer responsible for compliance
E
N
G
L
I
S
H
31