Installing Batteries And Setting The Clock - Nissei DS-1873 Instructions

Rest for approximately five minutes and take your blood pressure while relaxed in a quiet environment.
Take blood pressure measurement with the correct posture and do not move nor speak during
measurement.
Avoid exercise, eating, drinking alcohol, smoking and other activities that affect your blood pressure
right before a measurement.
Take your blood pressure every day at the same time.
The ambient temperature sould be approximately 20˚C when you take your blood pressure.

INSTALLING BATTERIES AND SETTING THE CLOCK

Turn the unit over and remove CUFF HOLDER
1
from the unit.
2 Open the battery cover.
Never forcefully remove CUFF HOLDER or the battery cover.
Install four "AA" type batteries into the
3
compartment as indicated. Make sure that the
polarities correspond to the (+) and (-) marks.
Close the battery compartment cover.
4
Year flashes on the display.
Clock can be set only after the batteries are reinstalled. Adjust the clock
so that measurement results are stored with correct date and time.
5 Use M1 3 to increase the flashing number
and M2 to decrease the number.
4
Press ON/OFF BUTTON
6
to next step.
Day flashes.
7 Adjust day with M1 and M2 buttons.
8 Press ON/OFF BUTTON and month flashes.
Adjust month with M1 and M2 buttons.
9
to confirm and move
2
- 10 -
TIPS ON TAKING YOUR BLOOD PRESSURE
7
CAUTION!
Do not use rechargeable batteries.
battery replacement indication
Replace all the batteries when the battery replacement
indication appears on the display or nothing is displayed
even if ON/OFF BUTTON
Use alkaline batteries to increase battery life. Use of regular Carbon-
Zinc batteries will necessitate more frequent replacement. The
enclosed batteries are for monitoring, and their life may be shorter
than that of commercial batteries.
Since neither the device nor batteries are
household waste, follow your local recycling
rules and dispose of them at appropriate
collection sites.
Operation with an AC adapter
AC ADAPTER JACK
on the right side of the unit. Do not
use any adapters other than
the one specified below.
Specifications of the AC adapter to be selected are:
Output voltage
Input voltage range
Maximum electric load : 600mA or higher
page 3
see fig.1
is depressed.
2
is located
6
6
: 6 VDC ±5%
: Standard voltage ±15%