D-Link DAP-2690 Guide D'installation page 10

Your Setup is Complete
When you have completed the steps in this Installation Guide and configured
your for your network, your network should look similar to this:
To setup and manage the DAP-2690 from a computer, use one of the following
methods:
1. Connect a straight through Ethernet cable between the access point and
your computer.
2. Connect the access point to a switch or router and use a computer from a
computer that is also connected to that switch or router.
* Maximum Wireless signal rate derived from IEEE 802.11n specifications. Actual data throughput will vary.
Network conditions and environmental factors, including volume of network traffic, building materials and
construction, and network overhead lower actual data throughput rate.
TECHNICAL SUPPORT
8
D-Link DAP-2690 Quick Install Guide
dlink.com/support