1byone O00QH-0514 Manuel D'instruction page 3

Receiver:
EN
The receiver can be powered by 3 x type C batteries
DE
or by an adapter (output: DC 6V).
FR
a. If powered by batteries, please insert the batteries
using the following procedure:
ES
·Remove the screws on the back of the receiver
IT
with a screwdriver. Next remove the battery
compartment cover.
·Insert 3 x C type batteries into the battery
compartment, using the correct polarity to
eliminate the danger of fire.
·Replace the battery compartment cover and
tighten the screw.
b. If powered by an adapter (recommended adapter
SKU OUS00-0278): Insert the adapter's connector
into the DC power input jack on the side of the
receiver, then plug into a power outlet.
Safety Note:
For the receiver:
·Be sure to remove all batteries before connecting
to the adapter and plugging into a safe power
outlet.
·Do not expose the receiver to water spray or
- 03 -
water drops and do not place liquid-filled objects
such as vases or opened drink containers on or
near the receiver and the power outlet.
·If power by batteries, replace them when
exhausted with the same type and voltage
battery.
·Remove the batteries or unplug the adapter from
the power outlet if the Alarm kit is not to be used
for an extended period of time.
For the PIR sensor:
·The PIR sensor is powered by 3 x AAA batteries.
When exhausted, replace it using the same type
and voltage batteries.
·Always insert the batteries using the correct
polarity to eliminate the danger of fire.
·Keep old and new batteries away from children.
·Old batteries should be properly disposed using
safe environmental practices.
·Remove the batteries from the PIR sensor if you
do not intend to use the Alarm kit for an
extended period of time.
Low voltage indication: When the batteries are
exhausted, the LED indicator on the receiver and PIR
sensor will flash once every second to remind you to
replace the batteries.
- 04 -
EN
DE
FR
ES
IT