Inserting Threaded Cable Connection For Elbow Connector - Interroll DM Série Instructions De Montage

Version 2.0 (06/2018) en
Translation of original instruction manual
Interroll Drum motor DM series connecting cable
Installing the connecting cable

Inserting threaded cable connection for elbow connector

1 Assembly nipple
2 Assembly sleeve
3 Intermediate socket
4 Screw the assembly nipple (1) into the shaft end and tighten it with a 14-mm open-end
wrench. Ensure that the assembly sleeve (2) and the cable do not turn in the process.
4 Push the assembly sleeve (2) into the intermediate socket (3), align it and tighten it with the
locking screw (4).
4 Screw the shell nipple (5) of the screw connection into the intermediate socket and tighten it
with a 14-mm open-end wrench.
4 Screw the thrust screw (6) of the screw connection tightly onto the thread of the shell nipple
using a 20-mm open-end wrench.
4 Route the connecting cable properly and place it in the switch cabinet.
4 For the remaining installation of the drum motor, observe the notices in the Interroll drum
motor DM series operating manual.
1 2 3
4 Locking screw
5 Shell nipple
6 Thrust screw
4
5
6
23