GE GWS03ADWSS Manuel D'utilisation Et D'installation page 11

Problem
Wine chiller has odor
Moisture forms on
outside of wine chiller
Moisture collects inside
(in humid weather,
air carries moisture
into wine chiller when
door is opened)
Frost forms on interior
surfaces of wine chiller
Wine chiller too cold
Condensation on front
of door
Water on floor behind
wine chiller
Possible Causes
Interior needs cleaning.
Not unusual during periods
of high humidity.
Too frequent or too long
door openings.
Wine bottles touching
the back wall.
This is normal.
Door left open.
Temperature control
is set too cold.
The room temperature where
the wine chiller is located is
too cold.
Wine chiller is located
in a high humidity environment.
Door left open.
Tilting unit when moving.
What To Do
• See Care and cleaning.
•Wipe surface dry.
•Reposition bottles.
• See the Defrosting section.
• Excessive frost may form if the door is left open.
See the Defrosting section.
•Door is not self-closing. Always make sure that
the door is closed after opening.
•Check to see if a bottle is holding door open.
•See About the control and settings.
•For proper operation, the room temperature should
be equal to or greater than the set temperature
of the wine chiller.
•Wipe off the condensation with a clean, dry cloth.
• Locate the wine chiller in a lower humidity
environment.
• Door is not self-closing. Always make sure that
the door is closed after opening.
• Check to see if a bottle is holding door open.
• This is normal. The drain pan above the compressor
may be full following defrost. Check to make sure
no water spills when moving the unit.
ge.com
11