Technical Data; Customer Service - Henry Schein Maxima 900-3510 Mode D'emploi

Users manual
PLACING THE CUFF:
The cuffmust not be fitted over wounds as this could lead to further injury. Blood pres-
sure must always be measured on the arm with the higher pressure values. To do this,
first measure blood pressure on both arms and subsequently always on the arm which
produced the higher reading. Place cuff in such a manner that the lower cuff edge
finishes ca. 2 - 3 cm above the elbow and the centre of the rubber bag rests on top of
the artery.
TAKING THE BLOOD PRESSURE:
Inflate the cuff to above the systolic pressure. The air release speed can be adjusted by
rotating the valve screw.
The World Health Organisation (WHO) recommends a deflation speed of 2 - 3 mmHg per
second. After the measurement is completed, fully open the air release valve to allow
for the fast deflation of the cuff.

TECHNICAL DATA:

Measurement range: 0 - 300 mmHg
Accuracy of Pressure indication: ± 3 mmHg
Storing conditions: -30°C - 70°C,15 - 85% rel. humidity
Operating conditions: 10°C - 40°C,15 - 85% rel. humidity
CLEANING OF UNIT AND CUFF:
• To clean the unit only use a dry, soft cloth.
• To clean the cuff – remove the rubber bag. The exterior of the cuff can then be washed
by hand at a maximum temperature of 30 degrees Celsius.
DISINFECTION:
We recommend non-alcoholic disinfection (Maxima Non-Alcoholic Disinfection) to di-
sinfect the device.

CUSTOMER SERVICE:

For repair work, please send the instrument carefully packed to you local Henry Schein
Office.
4