Installing The Ds2416 - Yamana DS2416 Mode D'emploi

8

Installing the DS2416

Installing the DS2416
The DS2416 installs into a PCI expansion slot and requires no special jumper
settings or interrupt settings.
See your computer's manual for full details on installing PCI cards.
Turn off the computer and disconnect the power cord.
1
Remove the computer's cover.
2
Choose an empty PCI slot for the DS2416, and remove the screw
3
from its expansion-slot cover.
To prevent static electricity from damaging the DS2416, touch a grounded
metal part of your computer, such as the power supply case, before handling
it.
Carefully align and insert the DS2416 into the PCI slot.
4
Secure the DS2416 using the screw removed previously.
5
Important: The DS2416 is grounded via the expansion-card fixing screw, so
be sure to tighten it securely.
Replace the computer's cover.
6
Turn on your computer.
7
When the New Hardware Found dialog box appears, select "Driver
8
from disk provided by hardware manufacturer", and then click OK.
When the Install From Disk dialog box appears, insert the driver
9
floppy disk into the floppy disk drive, and then click OK.
When the restart dialog box appears, restart your computer.
10
DS2416—Owner's Manual