LEXIBOOK MeteoClock Evolution Compact SM180 Mode D'emploi page 15

3. Press the "MODE/SET" key to confirm your setting.
4. To change the weather status again, press and hold the "+ (12/24)" key until the
current weather forecast symbol starts flashing on the LCD screen, then repeat
steps 2 and 3.
Note:
• If you do not set the current weather status or if the weather symbol selected is
incorrect, the unit's weather forecast may not be accurate.
• If the weather station is moved to another location significantly higher or lower
than its initial standing point (e.g from ground floor to 1st floor of a house), the
current weather status must be changed as well.
• The weather station will start the first forecast 6 hours after the current weather
status has been set. After setting up the weather status, reading for weather
forecasts should be discarded for the next 6 hours. This will allow sufficient time
for the weather station to operate at a constant altitude and therefore result in a
more accurate forecast.
• Absolute accuracy cannot be guaranteed regarding weather forecasting. The
weather forecasting feature is estimated to have an accuracy level of about 75%
due to the varying areas the weather station has been designed to be used in.
• If there is any inconsistency of weather forecast between your local weather
station and this unit, the local weather station's forecast should prevail.
Barometric pressure trend
The trend indicator shows the recent trend of the barometric pressure. Generally,
bad weather is associated to a low atmospheric pressure and good weather to a
high atmospheric pressure.
The barometric pressure trend is increasing.
The barometric pressure trend is steady.
The barometric pressure trend is decreasing.
Copyright © Lexibook 2009
15