Canon EF XL Mode D'emploi page 13

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio / TV
technician for help.
Do not make any changes or modifications to the
equipment unless otherwise specified in the manual. If such
changes or modifications should be made, you could be
required to stop operation of the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This digital apparatus does not exceed the Class B limits
for radio noise emissions from digital apparatus set out in
the Radio Interference Regulations of the Canadian
Department of Communications.
Specifications
Compatible lenses
Canon EF lenses*
Camcorders with a XL system
Compatible
mount compatible with the EF
Camcorders
Adapter.
Mount
Front mount
EOS Mount System
Rear mount
XL Mount System
Operating power
Camcorder power supply and
lithium battery (2CR5)
113 × 89 × 39mm
Max. Dimensions
(W × H × D)
(4-7/16 × 3-1/2 × 1-9/16 in.)
Weight
220g (7 3/4 oz)
(without lithium battery)
* When an EF lens for 35 mm is mounted on a 1/3-
inch CCD image sensor camcorder, the focal length
will increase by 7.2 times (in 35mm equivalent).
Weight and dimensions are approximate.
Subject to change without notice.
Errors and omissions excepted.
13

Publicité

Table des Matières
loading

Table des Matières