Thermador TCM24TS Manuel D'utilisation page 36

en Simple troubleshooting
Problem
Bean container sticks when
inserting�
The coffee grounds are not
compact and are too wet�
Grinding level adjustment
is stiff.
Brewing unit cannot be
inserted�
Protective cover of the
brewing unit cannot be
properly attached�
There is water under the
drip tray�
Display shows
"12:00"
Display shows
"Milk container connected?"
despite connected milk
container�
Display shows
"Overvoltage or
undervoltage"
Display shows
"Leave device to cool"
Display shows, for example:
"Fault: E0510"
Display shows
"Fill bean container"
although the container is
already full, or the grinder is
not grinding any beans.
32
Cause
There are beans in the
housing�
The grinding setting is too fine
or too coarse, or not enough
ground coffee has been used.
Too many beans in the
grinding unit�
Brewing unit is in the wrong
position�
Brewing unit is locked�
Brewing unit is not locked�
This water is condensation�
Power failure or appliance
switched off at power switch.
Container is outside the range
of the sensor�
Material e�g� milk carton is not
recognised�
Voltage too high or too low�
Appliance is too hot�
The appliance has a fault�
Beans are not falling into the
grinding unit (beans too oily).
Solution
Remove the beans.
Adjust the grinding unit to a
coarser or finer setting, or use
2 level measuring spoons of
ground coffee.
Dispensing a drink from coffee
beans. Only make any subse-
quent changes to the grinding
level in small steps�
Insert the brewing unit according
to the instructions, see the
section "Cleaning the brewing
unit".
Unlock the brewing unit, see the
section "Cleaning the brewing
unit".
Lock the brewing unit, see the
section "Cleaning the brewing
unit".
Do not insert drip tray without
cover�
Re-enter values; do not switch
the appliance off at the power
switch or select the "Off" option in
the Clock display menu�
Position the container at the right
edge�
Confirm the display request with
"yes" or use the enclosed milk
container�
Contact electricity or grid
provider� Have the power supply
checked by an expert.
Switch off appliance for
30 minutes�
Proceed according to the display
screen�
Gently tap the bean container.
Possibly change the type of
coffee. When the bean container
is empty, wipe it with a dry cloth�