Thermador TCM24TS Manuel D'utilisation page 32

en Service programs
● Place a container with a capacity of 17 oz
(0.5 l) under the beverage outlet.
● Press C� The cleaning
program will now run for about 5 minutes.
● Remove the container, empty the drip
trays, replace and close the appliance
door�
● Press C� The appliance
has finished cleaning and is ready for use
again�
● Press E to exit the program�
Clean & Descale
Takes about 26 minutes.
Clean & Descale combines the functions
Descale and Clean. If both programs are
due to be carried out close together, the
fully automatic coffee machine will auto-
matically suggest this service program�
● Press E�
● Select "Clean & Descale" with the K or
L arrow button.
● Press C� The display
indicates the progress of the program�
● Clean and re-insert the beverage outlet,
empty, clean and re-insert the drip tray
and coffee grounds container�
● Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer�
● Remove the water filter (if there is one)
and press C�
● Pour lukewarm water into the empty
water tank up to the "0.5 l" mark and then
dissolve one Thermador descaling tablet
00311820 in it�
Note:
If there is not enough descaling solution in
the water tank, you will be asked to do the
following. Refill using uncarbonated water
and press C again�
● Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container�
● Close the appliance door�
● Place a container with a capacity of 17 oz
(0.5 l) under the beverage outlet.
28
● Press C�
The program will now run for about
19 minutes�
● Remove the container and press
C�
● Replace the water filter (if removed).
● Fill the tank with fresh water up to the
"max" indicator.
● Replace the water tank and close the
door�
● Place the container underneath the
beverage outlet again.
● Press C�
The program will now run for about
7 minutes and rinse the appliance�
● Remove the container, empty the drip
trays, replace and close the appliance
door�
● Press C� The appliance
is descaled, cleaned and ready for use
again�
● Press E to exit the program�
Special rinsing
NOTICE:
If any of the service programs are ever
interrupted, for instance by a power failure,
please proceed according to the informa-
tion on the display:
● Rinse the water tank and refill it with fresh
water up to the "max" mark.
● Press C� The program will
now run for about 2 minutes and rinse the
appliance�
● Empty the drip trays, replace and close
the appliance door� The appliance is
ready for use again�
● Press E to exit the program�