Technical Data; Symbols And Their Meaning - Wolfcraft MASTER cut 1000 Traduction De La Notice D'utilisation Originale

INTRODUCTION
• PLEASE NOTE: Do read all safety & other instructions that have come with the Master cut 1000 and with the power tools you use for work.
Failing to observe the safety & other instructions may cause electric shocks, fire and/or severe injuries.
• Do keep the operating instructions for future reference in a safe place.

TECHNICAL DATA

dimensions (put up for use):
dimensions (folded up):
worktop:
maximum height of work piece:
maximum cutting width with parallel guide:
diameter of the clamping holes:
load-bearing capacity:
weight:

SYMBOLS AND THEIR MEANING

Warning against a general danger
Read the instructions!
Goggles must be worn.
Hearing protection must be worn.
Dust mask must be worn.
Pull the plug.
INTENDED USE
The MASTER cut 1000 is a multi-purpose work and machine table. It is suitable for
• the installation of a hand-held circular saw with splitting wedge on the machine plate, with the saw blade having a maximum diameter of 200 mm
and a maximum cutting depth of 66 mm. Do only use saws within the above maximum dimensions of the base plate (see Fig. 3.1).
Use the gap insert. It makes the Master cut 1000 a stationary circular saw bench.
• using it as jigsaw table.
• using it as milling table exclusively in combination with the parallel milling guide (Art.-No. 6114000) and for 230-V routers with a maximum rating
of 1800 W. The milling machine must not be used in combina-tion with the guide bar.
• being used as workbench for processing work pieces (e.g. drilling, grinding etc.).
• Do observe the manufacturer's safety & other instructions for the machines used as well as the safety instructions for the machine table.
• When disposing the Master cut 1000, please observe the local disposal regulations.
The user is liable for all and any damage and accidents that have been caused by improper use.
GENERAL SAFETY INSTRUCTIONS
• Keep your workplace clean and well lit. Poor housekeeping or unlit working areas may result in accidents.
• Do not work with power tools in an explosive ambience, where flammable liquids are kept and where gas or dust occur. Power tools will generate
sparks which might ignite the dust or vapours.
• Keep children and other persons off your workplace, while using power tools. When getting distracted you can lose the control over the
equipment.
• The plug of the power tool must fit into the socket. The plug must not be tampered with. Do not use adapters together with grounded power
tools. Unmodified plugs and matching sockets will reduce the risk of getting an electric shock.
• Keep power tools out of the rain and away from wetness. Water penetrating into a power tool will heighten the risk of getting an electric shock.
• When working with a power tool outside, use only extension cords that are suitable for outdoor use. Using an extension cord that is suitable for
outdoor use will reduce the risk of getting an electric shock.
t
855 x 540 x 865 mm (width x depth x height)
590 x 757 x 1440 mm
855 x 540 mm
circular saw bench 60 mm
circular saw bench 510 mm
20 mm
200 kg
21 kg
Do not use the machine for cutting firewood.
Use only hand circular saws with a maximum cutting depth of 66 mm.
Use only saw blades with a maximum diameter of 200 mm
for your hand circular saw.
Set the cutting depth of your hand circular saw before every cut in such a way
that the saw blade does not protrude more than 4 mm from the work piece.
Use only machines with a maximum output of 2760 W.
25
Use only hand circular saws with a riving knife.