Installing The Water Filter - Panasonic NR-BS53VX3 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 71
Connecting the refrigerator
Before proceeding any further, be absolutely sure to check that the power plug has been disconnected from the power outlet. And check
the main water supply line has been shut off.
When you want to connecting the refrigerator to the water supply, please contact your dealer, an authorized service centre or access to
our Web site (http://panasonic.net).
We could not be held responsible if you connect the refrigerator by yourself.
Attach the hose connector to the water service pipe opening.
a
Turn the hose connector clockwise to attach it.
● After tightening up the hose connector as far as it will go by hand, use a tool to further tighten the hose connector through
another half-turn or so.
● Check that the strainer is fitted inside the hose connector.
b Insert the coupling hose connector into the water service hose.
c Insert the water service hose into the end of the hose connector.
● The water service hose is firmly inserted into the end of the hose connector.
d Tighten the coupling hose connector to the hose connector.
Turn the coupling hose connector clockwise to attach it.
● Tighten the coupling hose connector until space is lost between coupling hose connector and hose connector.
Case of G 3/4
a
Water service pipe opening
After the connection ends, turn on the main water supply line, and check that no water is leaking.
Notes:
● Failure to follow the steps as given above may cause water to leak.
● Coil the excess length of the water service hose at the back of the refrigerator.
Attach the hose connector to the G 1/2 type
water service pipe opening.

Installing the water filter

The water filter is not installed at the time the refrigerator is purchased.
Install the water filter provided with the refrigerator.
Remove the drawer of the Vitamin-Safe Zone.
a
b Remove the filter panel.
Place your fingers in the cutout at the front of the filter panel, and remove the filter panel.
c Install the water filter and rotate it 90 degrees clockwise.
d Push the water filter down, and put the filter panel back in place.
Filter panel
b
Note:
● Run water through the Water dispenser until the water runs clear (15 glass (approx. 3 litre)). This will clean the water supply system
and remove air from the water supply hose.
Hose connector
Strainer
Case of G 1/2
Water service pipe opening
a
Coupling hose connector
c
b
Water service hose
Joint
a -1
Packing
c
Water filter
Installation
d
Hose connector
a -2
Strainer
d
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Nr-bs53vw3

Table des Matières