Trouble Shooting - Siemens LC98KA570 Notice D'utilisation

Removing metal mesh grease filter
The metal mesh grease filter is located in a filter holder above
the extractor hood, in the flue.
1. Pull the filter holder out of the flue.
Note: Grease can collect in the bottom of the filter holder.
Hold the filter holder at an angle to prevent grease from
dripping out.
Open the metal mesh grease filter lock and remove the filter
2.
from the holder.
3. Clean the metal mesh grease filter and its holder.
4. After removing the filters, clean the inside of the appliance.
Installing the metal mesh grease filter
Insert the metal mesh grease filter into its holder.
1.
2. Insert the filter holder back into the flue.
Note: The filter holder can only be inserted if the metal mesh
grease filter lock is facing upwards. If the filter holder cannot
be inserted easily, do not use force, but turn the filter holder
over.
Cleaning the inside of the appliance
Note: Grease can collect under the ventilation panels. You can
remove the ventilation panels to make it easier to clean the
inside of the appliance.
Open the ventilation panels as described in the section
1.
Operating the appliance.
2. Take hold of the outside of the ventilation panel (both sides),
and carefully pull it out of the locking mechanism.

Trouble shooting

Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out and damaged power cables replaced by one of our trained
after-sales technicians. If the appliance is defective, unplug the
appliance from the mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
3. Slide the ventilation panel to the right in its holder, and
remove.
Clean the ventilation panel and the inside of the appliance.
4.
5. Insert the ventilation panel into its holder and slide it to the
left.

Holding the ventilation panel at both sides, first push it
6.
upwards and then downwards into the locking mechanism.
Malfunction table
Problem Possible cause Solution
The appliance The plug is not
does not work plugged in.
Power cut
Faulty fuse
The button illu- The control unit
mination does is faulty.
not work.
The lighting The bulbs are
does not work. faulty.
--------



Connect the appliance
to the electricity supply
Check whether other
kitchen appliances are
working
Check in the fuse box to
make sure that the fuse
for the appliance is OK
Call the after­sales serv-
ice.
Call the after­sales serv-
ice.
15