Important Safety Instructions; Grounding Instructions - NSS Maverick 300 Instructions D'origine

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
conductor can result in a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to whether the outlet
is properly grounded. Do not modify the plug provided with the
machine. If outlet is not suitable for safe use; have a proper outlet
installed by a qualified electrician.
Always use a properly grounded 3-wire extension cord, which has
male and female plugs. If 25ft [7.6m] extension cords are used, the
electrical carrying capacity should be no less than 14-3 ST. 50ft
[15.2m] extension cords no less than 12-3 ST.

GROUNDING INSTRUCTIONS

This machine shall be grounded while in use to protect the operator from electric shock. The machine is
provided with a three-conductor cord and a three-contact grounding type attachment plug. The plug must be
plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes
and ordinances. The green conductor in the cord is the ground wire. Never connect this wire to other than
the grounding pin of the attachment plug.
Check nameplate on the machine to be sure voltage and cycle stated is the same as the electrical outlet. Do
not attempt to plug a 120-volt machine into a 240-volt outlet or a 240-volt machine into a 120-volt outlet. If the
machine is provided with an attachment plug as shown in Figure A. below, it is intended for use on a nominal
120-volt circuit. If a properly grounded receptacle as shown in Figure A. is not available, an adapter may be
installed as shown in Figure B. if the outlet box that houses the receptacle is grounded. Be sure to fasten the
grounding tab (the green colored rigid ear, lug or the like extending from the adapter) with a metal faceplate
screw.
If the machine is provided with an attachment plug as shown in Figure C., it is intended for use on a nominal
240-volt circuit. Changes to the attachment plug or use of adaptors to other plug types must be done in
accordance with local regulations.
NOTE: In Canada, the use of a temporary adaptor may not be permitted by Canadian electrical code.
ALL REPAIR SERVICE MUST BE PERFORMED BY AN NSS AUTHORIZED DISTRIBUTOR/
SERVICE STATION USING ONLY NSS ORIGINAL EQUIPMENT PARTS.
GROUNDING OF ELECTRICAL EQUIPMENT
Improper connection of the equipment–grounding
SAVE THESE INSTRUCTIONS