NSS Maverick 300 Instructions D'origine page 6

SYMPTOM
Motor runs intermittently.
Motor not running.
Motor slow speed only.
Motor runs / pad does not turn.
Wall breaker blows.
Machine wobbles or bounces
Machine vibrates / buzzes
Authorized Repair Service
Repair service for this machine must be performed by an NSS authorized service center. Repairs performed
by an unauthorized company will void the machine warranty. If you require assistance finding an authorized
service center, contact NSS Enterprises.
TROUBLE SHOOTING
CAUSE
Loose wire.
Broken or damaged cord.
Bad handle switch.
Loose wires.
Broken or damaged cord.
Bad handle switch.
Blown capacitor.
Burned stationary switch.
Shortened windings.
Bad Capacitor.
Motor stuck in start winding.
Broken odum coupling in Gearbox.
Excessive load on circuit.
Pad / brush over loaded.
Under sized extension cord.
Improper use.
Warped / damaged pad driver or
brush.
Pad not centered.
Worn motor bearings.
Wheels loose on axle.
SOLUTION
Check all wire connections.
Replace cord.
Test continuity - replace.
Check all wire connections.
Replace cord.
Test continuity - replace.
Replace capacitor.
Replace stationary switch.
Replace stator with frame.
Check capacitor.
Check stationary switch.
Replace odum coupling in
Gearbox.
Check total load on circuit.
Check / change procedures.
Replace / remove extension cord.
Consult distributor.
Replace pad driver / brush.
Center pad.
Replace motor bearings.
Shim wheels tight on axle.