Battle Creek Thermophore MaxHEAT Plus Mode D'emploi page 5

Position the cover and heating pad assembly over the area of the
body needing heat therapy. The heat pack layer should be on the
outside (farthest away from your body) and the section with the
damp cloth on the inside (closest to your body).
If you have purchased the Petite-size 4" x 17" heat pack, it also
has a Velcro strap to help hold it in place on small joints such as
the ankle, elbow, neck or jaw.
Please note the UL-required warning:
Do not sit or lay on the Thermophore
Using Your Switch:
Classic Easy-Comfort™ Switch
When you are ready to begin your therapy session, position the
Thermophore Deep-Heat™ System over the area you wish to treat.
®
Direct contact with bare skin or over light clothing produces the
most benefit. Make sure the unit is lying smoothly on your body, so
it can conform to your body's curves and make close contact with
painful areas.
Insert the plug into any convenient 110-volt outlet. The pack has a
polarized plug (one blade is wider than the other) as a safety fea-
ture. This plug will fit into a polarized outlet only one way. If the
plug does not fit fully into the outlet, reverse the orientation of the
plug in the outlet. If it still does not fit, contact a qualified electri-
cian. Do not attempt to defeat this safety feature.
Press the lever on the hand control and hold it down. WARNING:
This switch was designed for your safety - USE ONLY AS DIRECTED.
The switch is spring-loaded so the Thermophore
the switch is not held "On". You control the heat by holding the
switch in your hand. Please do not switch it "On" any other way.
When the Thermophore
switch until you begin to notice that the unit feels cool. Repeat the
"On and Off" procedure for another quick pulse of intense moist
heat, and repeat as needed to stimulate circulation, relax muscle
spasms, and give an adequate deep-heat therapy treatment.
Pack gets as hot as you like, release the
®
heat pack.
®
Pack is "Off" when
®
Page 4