First Installation; Batteries Installation; Starting; Working Mode Definition - Watts BT-D Mode D'emploi

1. Operating mode menu (active mode is framed).
2. parameter number if "3" is displayed.
3. Installation Parameter menu.
4. Type of sensor used and temperature displayed.
Regulation => Internal or external ambient sensor.
Regulation => Floor sensor.
Regulation => Internal sensor with Floor limitation.
View of the outside temperature
5. Heating demand indication.
6. Low batteries indicator.
7. °C or °F unit indicator
8. Setting or measured temperature if "2" is displayed. Parameter value if "3" is displayed.
9. Key lock indicator
2

First Installation

This section will guide you to set up your thermostat for the first time.
2.1

Batteries installation

- Open the two sides covers and Insert the 2 AAA Alkaline supplied batteries (or remove the small protection sticker if the
batteries are already installed in the compartment)
- Close the two side's covers.
- Now your thermostat will propose you to adjust the current time and date.
2.2

Starting

The thermostat is now ready to works.
The default working mode will be Comfort
3

Working mode definition

How to change the working mode?
- Open the small center cover to have access to the navigation keys (◄) or (►).
- You can now press theses keys to display the working mode line.
Move the frame cursor on the desired working mode and press (OK) to enter in the operating mode you have chosen.
3.1

Manual mode Comfort

Manual working mode, the comfort setting temperature will be followed all the time.
By pressing (-) or (+) keys, the comfort setting temperature starts to blink and can be adjusted.
3.2

Manual mode, Reduced

Manual working mode, the reduced setting temperature will be followed all the time.
By pressing (-) or (+) keys, the reduced setting temperature starts to blink and can be adjusted.
3.3

OFF mode

Use this mode if you need to switch off your installation.
Be Careful:
In this mode your installation can freeze.
- At any time, when display is off, press on the (Ok) key to display a few seconds the current temperature and time.
- To restart your installation, use the navigation keys (◄) or (►).
8