Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
Recommended Maintenance Intervals
NOTICE: Always turn unit off and unplug before
performing any maintenance.
DESCRIPTION
1 Clean the fuel lank
2. Replace the fuel filler
3. Seneice the burner
4. Inspect the neat exchanger.
1. Cleaning the fuel tank.
The fuel tank should be cleaned out once a year. To
clean the tank, follow these steps:
a. Place an appropriate container beneath the drain
plug to catch any fuel.
b.Remove the drain plug with a wrench.
c Allow the tank to drain completely.
d. Replace the drain plug.
e. Dispose of waste fuel in accordance with tocal
regulations.
WARNING!
Diesel fuel and diesel/kerosene
are flammable and potentially explosive. Always tu
off and unplug the Dragon before draining the fuel
tank. Do not smoke while draining fuel. Keep away
from open flame.
2. Replace the fuel filter
Replace the fuel filter once a year. The filter is a spin-on
type and is located inside the right side cabinet behind
the control panel Have rags or paper towels on hand to
clean up any spills, and dispose of the filter and waste
fuel according to local regulations. You must bleed all air
from the fuel lines and allow the filter to fill with fuel
before the burner will ignite. See "Bleeding the fuel
li nes," p_ 4.
3. Servicing the burner
Copies of the AFIAFG Oil Burner Manual and the
GeniSys Model 7505 Advanced Burner Control Manual,
published by R.W. Becket Corporation. are included with
your Dragon documentation. Please refer to these
documents for information about servicing the burner
4. Servicing the heat exchanger and
combustion chamber
In ti me, soot may accumulate in the the heat exchanger
and combustion chamber. To ensure proper operation,
Kinclerkarnack
141
Rd. Park Ridge, NJ 07656 Tel 201-782-1782 Fax. 201-782-1783 Web
I NTERVAL
Yearly
Yearly
Refer to
manufacturer's manual
Yearly
mixture
Ap
.4
l
"i
n9
Air Marketing Group (,LC
these components should be inspected once a year and
cleaned if necessary by a qualified HVAC technician.
Contact your local distributor or the Dri-Eaz Service
Department at 800-932-3030 for the location of a service
center near you.
5. Cleaning the housing
To clean the Dragon housing, use a cleaner with a
degreasing agent such as Unsmoke Degrease-All
Accessories Included
The Dragon X2 Mobile Furnace includes the following
parts and accessories:
3 25 ft sections of 8 in. (7.6 m
temperature ducting. One end of each duct is fitted
with a sewn-in cuff and integrated belt and buckle.
1 thermostat with 60 ft. (18.3 m) sensor cord.
1 Owner's Manual (Dri-Eaz)
1 AFIAFG Oil Burner Manual (Becket)
1
GeniSys Model 7505 Advanced Burner Control
Manual (Becket)
Service
For parts and service call your local distributor or the
Dri-Eaz Service Department at 800-932-3030 or
360-757-7776. Copies of the Dragon manual and related
information are available at www.Dri-Eaz corn.
Go to warranty Dri-Eaz.com to register your purchase.
SPECtFICATIONS
Dragon H2 Portable Heater
Model
F429
Dimensions. including
74
v
trailer (IN v H
D)
1 9
1 500 lbs i 680 kg
Weight
GVRVV
2000 lbs I 907 kg
Tongue weight
200 lbs I 91 kg
Power
1 0 amps, 120 volt. 60 Hz
Net heat output
100.000 BTU/hr I 29 3 kWh
Airflow
1600 CFM I 2720 CMH
Healer cut off temperature
1 80°F 1 82°C
Fuel tank capacity
60 gal. I 227 liter maximum
No 1 or no 2 diesel or fuel oil
Fuel type
Kerosene may be added to fuel
for cold weather operation.
Fuel consumption rate
.8 gal /h I 3.0 liter/hr
Fuel pump pressure
140 psi I 966 kPa
ETL certified to CSA 8140 8-
Safety
1 967 (Reaffirmed 20011 Portable
Industrial Oil-Fired Heaters
Specifications are subject
change without notice. Some
to
values
may
approximate.
be
www amgair
x
20 cm) high-
v
v
116
54
in.
v
r
1.4 t
3.0 m
corn
corn Email: info@amgair
Publicité
Table des Matières
